Ask Experts Questions for FREE Help !
Ask
    furnaceguru's Avatar
    furnaceguru Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 23, 2009, 05:20 AM
    Lennox G41 Series
    My Lennox Furnace G41 Series keep blowing the 3 amp fuse on the printed circuit board

    Furnaceguru
    :cool:
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jun 23, 2009, 06:49 AM
    Look for a short in the low voltage wiring or test/replace the board. You might look on the back side of the board for burn marks
    siberianair's Avatar
    siberianair Posts: 360, Reputation: -4
    Full Member
     
    #3

    Jun 23, 2009, 12:54 PM

    Does it short when ac comes on?
    Can you turn fan on and not short the fuse?
    Careful checking the board... fingerprints can damage the board if it is not already damaged.
    Also check the t stat wiring around the unit and make sure nothing has chewed through it or it is not showing copper anywhere.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lennox Elite Series HS29-030-1P Problems [ 9 Answers ]

Hi, I have a Lennox Elite Series HS29-030-1P air conditioning unit and the compressor will not start. You will hear a buzzing sound then it stops, it about a minute it tries again then stops. What are the best ways to test the starter cap and the compressor to isolate the problem. The starter...

Furnace Fan stays on - Lennox G61MP Series Units [ 2 Answers ]

Hi, My Furnace fan started this morning and is now on for the whole time. I tried switching off-on the Furnace mains but as soon as I start the furnace again, the fan starts. I have just switched off the home Thermostat that controls the overall heat in the house (its in my passage) and now the...

Lennox G40DF Merit Series furnace won't run [ 1 Answers ]

I have a 2004 Lennox model # G40DF-48C. My small lower blower motor will kick on for about 4 or 5 seconds then shuts down. Everything will work fine with the a/c on, only have problem with heat. Both red and green lights are alternating a fast flash. Is this the ignitor or do you have any other...

Lennox G40 Series blowing fuses [ 1 Answers ]

I have a Lennox G40 Series furnace that keeps blowing the 5 amp fuse on the circuit board. Unit will come on, burners will ignite, blower comes on & 5 min later, "pop". I've replaced the programmable thermostat to no avail. Put the old original thermostat back on that didn't work either. However...

Lennox Elite Series Thermostat Very Loud Click On/Off [ 3 Answers ]

Our touch screen thermostat is very loud when it shuts on and off. I know this is due to the electrical relay but I am wondering if a different model would be quieter.


View more questions Search