Ask Experts Questions for FREE Help !
Ask
    chris100274's Avatar
    chris100274 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 18, 2011, 05:18 PM
    I just replaced my thermo couple in my gas heater, I notice it is glowing red orange
    Due to the flame hitting it. Is this OK for the couple. Is it supposed to be continuously glowing that hot?

Check out some similar questions!

Thermo goes below desired temp and will not initiate cycle. Thermo replaced HELP! [ 0 Answers ]

House temp goes below thermostat setting and furnace will not cycle unless I shut the system off and restart it again. This will give me two cycles and I have to start it all over again. I replaced the thermostat last week and it worked and cycled fine until today... What am I looking at?

Thermo couple [ 11 Answers ]

I had a thermo couple replaced in my furnace yesterday and I was charged 132.45. Is this a bit much?

My Pilot still off after replaced thermo coupling [ 3 Answers ]

I replaced my thermo coulping to my water heater and my pilot still does not stay lit, what else can the problem be. I appreciate any suggestions. Thank you

Thermo couple didn't work [ 1 Answers ]

I have replaced thermocouple and cleaned the best I could The piot stays lit for a while but now it won't fire up at all? And then the pilot goes out Major draft inside of furnace also Is thst normal?

Gas heater flame is orange instead of blue [ 1 Answers ]

The flame on my heater is burning orange rather than blue can you please advise what is wrong?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.