 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
My gas furnace (Ultra SX90 Armstrong)will not work when my thermostat (Thermostat – Honeywell - RTH230B) is switched to "auto". When the thermostat is switched to "on" it runs fine (or, at least, it did until I altered the programming on the thermostat this morning-- now nothing seems to work). ...
I have an intertherm furnace, and sometimes it cycles just fine, while other times it will do this: Ignition coil warm up Gas turns on and starts to warm up furnace Gas cuts off just as blower winds up Blower runs, blowing cold air through the house Blower stops Then this cycle repeats...
I have a Lennox Pulse 21 furnace and the fan won't work when I have the heat set on auto. The furnace will start, but after about a minute it shuts off without the fan ever starting. If I leave the fan setting "on" it runs constantly at high speed and the furnace also works. I went to a few local...
This is a 15 old unit I checked it yesterday and everything seems to work all right on manual mode but when turned on auto it fallows all steps but when it sends signal for fan to go on it does not work
Is it better to leave the fan set to auto or always on, especially during extreme cold conditions when furnace is kicking on much more often? The furnace is 3 years old.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
