I have a intertherm model M3RL080A BWT blower stays running all the time and will not heat, status light blinking one flash and the panel says, Limit circuit open or external load on 'W'. Can you help
Check out some similar questions!
Intertherm furnace blower stays on - no heat/cold air [ 4 Answers ]
Thanks for taking a moment to read - I've reviewed a lot of posts, however still cannot find one that explains why my Interthem G5RC100-16 gas furnace blower will not shut off even after the thermostat has been shut off. I'd also like some help, please, finding the "codes" for the blinking light...
Blower on furnace stays on. Ignitor does not come on. No heat. What could be wrong? [ 2 Answers ]
I have a 13 yr old Trane furnace. I have just replaced the thermal switch and flame sensor. The ignitor and flames no longer come on. The fan runs constantly with no heat. What could the problem be?
Intertherm furnace blower comes when it does not call for heat [ 2 Answers ]
The blower comes on when the furnace is not calling for heat
Furnace Blower stays on, no heat [ 2 Answers ]
Hello, I have an older Bryant furnace model # 396gadd36075. I turned on the heat the other day and the no heat. I notice the unit had been turned off (pilot was not lit), apparently by the service company I use when they came to do the spring check for the AC. I followed the instructions to...
Heat won't come on and blower stays on all the time. [ 1 Answers ]
I have a problem with a furnace that the heater won't come on, "not at all", and the Blower it stays running all the time, can't turn it off unless disconnected. Before replacing the Circuit Board, I will appreciate if somebody tells me what other reasons are there that may cause this problem. ...
View more questions Search
Add your answer here.