 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Installing new capacitor
I have a 1 HP 110 volt blower that got over headed due to clogged intake. When I looked inside the control box I noticed that the capacitor had leaked and was burned. I purchased a new capacitor and hooked it up. I assume since there are no + or - markings the two wires from the capacitor are interchangeable. When I turned the power on nothing happened.
Is there something special I needed to do to the new capacitor to charge it up? The fan turns freely by hand. I checked the switch with a meter and it works fine. Cheers Tom |
||||
Check out some similar questions!
OK I think I have narrowed my problem down to either a run capacitor or my start capacitor My fan on top of my unit runs but the compressor will hum for about 3-5 seconds every 5 minutes or so . Is it possible for my duel run capacitor to let the fan run but not let the compressor run, or is...
I have a problem with a ceiling fan capacitor I hope you can help me with. My daughter's fan was barely turning and according to the internet it was probably the capacitor. I removed it but was distracted a couple of times and apparently did not write down everything as I took the wires off. Bad...
Hello all, I have an older Amana HVAC system in my home. Home is 6yrs old. It Appears that my condenser unit was struck by lightning because one of the 3 terminals on the dual run capacitor was blown/melted and all the wires connected to the dual run capacitor were fried (It did storm the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
