 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Installing Honeywell RTH2300b
I am trying to install a Honeywell RTH2300B thermostat. I can't get the wiring. I have a red, blue orange, green, yellow, brown and white wire and B, O, G, Y, W, Not Used, R, and RC terminals.
How I have Wired: B-blue O-orange G-green Y-yellow W-white Not Used- R-red RC-jumped to red Extra brown wire Can anybody help me out? Thanks in advance. |
||||
Check out some similar questions!
Our old Venstar thermostat died this morning so we bought a Honeywell RTH2300B to replace it. We carefully labeled all of the wires before removing from old thermostat. We had R, Y1, W1, G and C. The instruction manual states that we should abandon the C wire. We following directions for...
Only two wires, one black and one white, are left over from my old digital thermostat. The white wire is attached to W and the black wire to O/B. Won't turn on the baseboard hotwater zone although it says HEAT ON zone and flashes RETURN. What Now?
I have a Honeywell RTH2300B Thermostat that I just installed. My heating system is a boiler with baseboard heat. I have three floors in my house and I have a thermostat on each floor. I only have three wires for each thermostat, a R, G, and W. When I hooked up the new thermostats the heat...
I'm installing new thermostat - all wires/lettering corresponds from old to new with the exception of new one has a slot for "w"but I have two wires left "w1" and "w2". "W1" is tan and "w2" is yellow. Thanks for the help!
Hello everyone, I am new here. I found this site which trying to troubleshoot my problem. Any assistance would be GREATLY appreciated. Basically I have an older honeywell programmable thermostat with 7 wires attached. They are as follows... C - Black wire L - Blue wire R- Red wire W2 - brown...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
