Ask Experts Questions for FREE Help !
Ask
    Roy Ybarra's Avatar
    Roy Ybarra Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 8, 2012, 09:13 AM
    Inducer motor staying on
    I have an amana m#guic090da50 s#9809130557 the inducer motor stays on and the trouble codes flashes two for pressure switch closed. But if I remove the suction hose frm switch to inducer motor then out it back the board clicks twice then the furnace lights up and operation is normal for one heating cycle. But the inducer motor stays on even after the heat cycle is done and even on cooling mode also when the system is switched to off on the thermostat. What can I check to try and fix the problem. I also noticed that the white wire from motor is connected to the power whip and the black runs to the board. Should it be connected to straight power or should both wires be connected to the board. Roy Ybarra
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Dec 8, 2012, 12:13 PM
    Sounds like you have a stuck induced draft relay. If the relay is on the control board, you will need a complete new control board.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What is a inducer motor [ 1 Answers ]

What is a inducer motor

Inducer motor? [ 1 Answers ]

When I turn my thermostat on at first I hear a humming then it blows hot air then cold air. I was told I need an Inducer motor? Does that sound correct?

How much for an inducer motor? [ 1 Answers ]

How much should it cost to replace a goodman inducer motor that is humming?

What is the inducer motor [ 3 Answers ]

I have a bryant 395C gas furnace and the inducer motor assembly is making noise. The motor seems fine and the furnace operates normally, but there is a plastic wheel attached to the end of the motor that is rattling when the motor runs. I've looked at pictures of many inducer motor...

Cracked inducer motor [ 3 Answers ]

Hello, I had a heating company come out and replace the ignitor on my furnace this morning. While they were here they mentioned that my inducer motor has a crack in it. They said if we don't have a new motor replaced this could cause carbon monoxide poisoning. Has anyone else heard of this? ...

View more questions Search