Howcan I tell if I need a new Ignition module

kbuxton Posts: 1, Reputation: 1

New Member

Nov 25, 2010, 07:31 PM

Howcan I tell if I need a new Ignition module

Furnace type is Coleman Evcon. Problem is, I replaced the hot surface ignitor. Furnace started working but in short cycles then it stopped totally except the purge fan is on constantly.

Check out some similar questions!

No power to ignition module or PCM ignition fuse, any thoughts [ 1 Answers ]

It's a 2001, Pontiac, Grand am, v-6 3.4. with the key in the on position there is no power to the ign mod, f/p inj, and pcm ing. so naturally its no start. I'm not sure of the circuit , the wire diagram is a little help, any suggestions? Frustrated

Ignition Module test [ 2 Answers ]

Hi guys Furnace : whisperheat with ignition box close and open The furnace carries ignition model and spark sensor pilot. On G/V you can see mp mp/mv mv which are all connected to the igniton module and grnd connected to the furnace . Now the problem : When you call for heat ,the...

Changing out ignition module [ 4 Answers ]

I'm in the process of changing out a G60RBG-3 for an S8610U Universal Intermittent Pilot Module. What is the correct location for the wires? Make: Bryant Model: 585JJ030075 Gas furnace.

Ignition module replacement [ 1 Answers ]

How do you locate and replace ignition module in my chevy 1994 pickup 1500 350

Testing spark ignition module [ 11 Answers ]

Hi, I have an Armstrong hi-e furnace, that I suspect has a faulty spark module. (The blower control board, the gas valve, pilot, and spark device are all new). The module is a Honeywell S8660k. The manual says to test the spark at the module. Can anyone tell me how to go about that? The lead to...

View more questions Search

Check out some similar questions!

Add your answer here.