 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How do you reverse polarity when replacing circuit board
Replaced circuit board (honeywell) on my heat pump unit with new, retailer said be mindful of polarity, you may have to reverse it. Sure enough, red light blinks nine times, manual says you have reverse polarity or not grounded, its grounded, so how do I reverse polarity ? Thanks
|
||||
Check out some similar questions!
My goodman pgb03075-1a stop blowing air. Took it apart and saw no flame when auto ignition fired 3 tries. It shuts off then led light constantly flashes. Not one of issues listed. Called goodman co. They said it was reverse polarity how do I fix?
I recently was replacing a damaged outlet in a barn that is on it's own circuit from a breaker panel. I wired it correctly (black to brass, white to white, etc.) and plugged a polarity tester into the outlet to double check when I was finished. It showed reverse polarity; as I go around the barn...
I have a goodman gmp 1004 gas furnace the old board has to be replaced pt#(18099-6)with a b18099-13 the wiring is not the same is there any thing that I showld look not to do before I attempt to install the new board I did mark every single wire when I took the old board Any help is greatly...
Hello, If someone can help me understand what is meant by reverse polarity in an outlet in my house? I'am selling my house and the inspector want an outlets reverse polarity fixed. Where do I start?:confused:
I have a Carrier gas furnace that is not getting gas; the rest of the cycle runs properly, including the HSI glowing, but there is no gas to light, so the system shuts down and I get a 21 error code (gas lockdown). I am showing no voltage to the gas valve at the point in the cycle when control...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
