Ask Experts Questions for FREE Help !
Ask
    jackleg 824's Avatar
    jackleg 824 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 26, 2013, 05:58 PM
    How do you remove the high-limit on a upright 95% furnace
    The high-limit switch is mounted to the sealed burner chamber with two mounting screws. The switch is on the inside with the screws going through the compartment wall and then catching the switch. I don't see any way to access it. Surely you don't have to remove the cased coil to get to it.

Check out some similar questions!

Where is the high limit switch on trane furnace? [ 1 Answers ]

4 flashes on troubleshooting display says open high limit device, where is this device located on furnace?

High Limit Switch Gibson gas furnace [ 1 Answers ]

Furnace runs OK several days, limit switch (resettable) goes off. Reset and heater runs fine another couple of days then the same issue.

Where is the High limit switch on Ultra V Tech 80 Furnace [ 0 Answers ]

Ultra V Tech 80 Furnace, Red LED light flashes 4 times, indicating "high Limit Switch Open" blower is running but, no fire, no heat, any answers?

I have an armstrong air 80 v furnace. "high limit problems" [ 1 Answers ]

I have replaced the high limit switch, flame sensor and computor board. Right now the only way the furnace will run properly is if I bypass the high limit. Any ideas on what is wrong?

Where is the high limit switch on a luxaire furnace [ 2 Answers ]

Where is the high limit switch on my luxaire furnace so I can reset it. As soon as it calls for heat the led light flashes red four times and the code is limit switch open. Everything starts up the ventor motor and the blower but there is no flame. I need heat


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.