Ask Experts Questions for FREE Help !
Ask
    lizbeth374's Avatar
    lizbeth374 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 2, 2009, 01:57 PM
    How do I wire a thermostat, replacing Maple Chase with Hunter?
    I have a Maple Chase 09520 thermostat that I am replacing with a Hunter Just Right thermostat. There are 7 wires for the Maple Chase and only 5 for the Hunter. Which do I use? And what do I do with the extras? This is how it is wired in the Maple Chase:

    Blue-->C
    Red-->R
    Yellow-->Y
    White-->E
    Green-->G
    Brown-->W2
    Orange-->O

    The Hunter has the following slots

    G, W, Y, Rh, Rc

    Any help would be appreciated
    Thanks!
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 2, 2009, 03:22 PM

    Do you have a heatpump? Looking at the wires from the old tstat I`d guess you have.,
    If so I see two problems
    1st you bought a hunter tstat, (junk)
    2nd the tstat is wrong for a heat pump

    Take the junk back,, and get a honeywell that is for a heatpump, if that's what you have
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #3

    Jan 2, 2009, 05:59 PM
    How did I know you were going to say that :p
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Jan 2, 2009, 06:09 PM
    Ditto
    Attached Images
     
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #5

    Jan 2, 2009, 07:24 PM
    Quote Originally Posted by MarkwithaK View Post
    How did I know you were going to say that :p


    You must have finally got that crystal ball back from the repair shop,, :),:)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maple/ chase thermostat [ 23 Answers ]

I let the batteries run low on my thermostat. I just replaced them but the display still reads "lo bat" and the heat does not kick on. I checked the fuse and it is still intact. Please help!!

Maple Chase Thermostat [ 1 Answers ]

I have a Maple Chase Thermostat that was flashing low battery. I changed the battery but now it stuck and continually says low battery. I can change or move from that mode and it will not allow me to turn heat on. Any suggestions? Thankshttps://www.askmehelpdesk.com/images/smilies/confused.gif

View more questions Search