Ask Experts Questions for FREE Help !
Ask
    florencef42's Avatar
    florencef42 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 22, 2016, 06:59 AM
    How to check my heil 7000 furnace operation
    I have a heil 7000 furnace (using propane). Should all three tubes have a flame?
    ma0641's Avatar
    ma0641 Posts: 15,681, Reputation: 1012
    Uber Member
     
    #2

    Dec 22, 2016, 10:36 AM
    Maybe maybe not. I have seen larger capacity heaters with an orifice plugged to reduce input BTU. However, furnaces are designed for the capacity on the rating plate. I would pull the burner to see if the orifice is blocked.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heil 7000 Gas Furnace [ 4 Answers ]

Heil Model # NUGK075DG08 I am stumped. Furnace was short cycling at first. Call for heat, Inducer motor comes on, Ignitor ignites pilot, Safteties all NC, Gas valve opens , burners lit, heat ing begins Blower fan comes on then roughly 1 minutes latrer kicks out on high limit. Found Dirty...

1992 Heil 7000 furnace [ 2 Answers ]

Last night I touch two red wires and a part fell of my furnace. I was able to put the part back on but it must be broken to come off that easy. I think it is called a flame rollout switch or sensor. Should this fall away from its location?

HEIL 7000 furnace [ 0 Answers ]

Furnace won't stay lit iv'e tried jumping limits and roll over switches volt meter reads 24 volts what should I do could it be the gas control valve?

HEIL 7000 gas furnace with 2 questions [ 0 Answers ]

Gas ignites stay lit till blower fan turn on then gas flames shut off. Then when calling for more heat same thing happens. Also, noticed some water/moisture in my draft inducer fan housing. Is the moisture normal since it does have hoses connected to it? Many thanks for the help. Rich

7000 Heil Furnace [ 1 Answers ]

My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...


View more questions Search