I just purchased a Beacon Morris garage heater. It is a BRU-75. I was wondering if anyone could tell me where I could purchase a thermostat for this particular model. I want to have a switch on the thermostat that will let me shut off the unit when I don't want it to run. I don't want to heat the garage all the time. It will not run an AC unit so I need a heat only thermostat. I checked at Menards and I don't think that they had one.
The second question is, how do you hook up the thermostat? The unit comes with directions but they certainly are not intended for layman such as myself. Any help would be greatly appreciated.
On the back of the unit it has terminals labeled R G W1 W2. Which two would I use? Since I want a thermostat with a switch on it, do I somehow hook it up so if the switch should get turned off while heating, the fan will stay running until the unit cools?
You really should check and or adjust gas pressure to be safe,especially if you are L.P gas. You will need a manometer to do so. If your gas pressure is too high you risk ruining your heat exchanger. Good luck!
Thanks for all the great help so far everyone. I hung the heater this weekend. I ran into a problem with venting to the outside. When I run the class be vent tubing, I need to run horiztonally with a slight pitch. Can I run the vent with a 90 degree elbow directly off the back of the unit, across the width of the unit, and then add a 45 degree angle just before it goes through the outside wall? I will attach a very rough sketch if I can figure out how to add attachment.
Sorry hvacservicetech_07 I meant so say agrees. I don't know why It says disagrees. I don't know how to change it.
I think your right. So now the question is how hard would it be to vent out of the roof. I am afraid to cut a hole in the roof because I am not sure how to make it water tight. Hmmm, I am going to have to think about this one.
I've been trying to hook up a couple of baseboard heaters, both w/double pole thermostats directly on the heaters. The people I bought the house from ran power to the first heater then from there to another. The first works fine and the thermostat controls the temp as it's supposed to but the other...
I bought a house and the gas was not yet completed to the home. The water heater is in and the water is connected to it but I need to connect it to the stub before the gas company comes and puts in the meter and turns on the gas. The gas flexible pipe is on the hot water. Do I just connect it to...
First I have bought a tree cnc mill 5 hp 3 phase
I need info on hooking up the 125 sub panel to my garage
Also I believe I need to install a new 200 amp main panel which is in a bedroom downstairs
The distance from the main panel to the garage is about 70 to 80 ft
I am not sure what kind of...