Ask Experts Questions for FREE Help !
Ask
    davidhartono's Avatar
    davidhartono Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 19, 2017, 09:50 AM
    Honeywell thermostat problem
    Hi, I have a Honeywell-TH8110U1003-VisionPro-Thermostat. One day the screen went off, and I changed the battery. However, the heater now can not be turned off. I temporarily shut off the circuit breaker, and when I checked the back of the thermostat, I found a burn mark.
    What can be done to fix this problem?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Apr 19, 2017, 12:29 PM
    If there is a burn mark, the unit is probably bad. However, I can't imagine a burn from a battery. Most burn marks I have seen are from lightning and possible related power surges.
    davidhartono's Avatar
    davidhartono Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Apr 21, 2017, 08:06 PM
    Thank you for the reply. When you mentioned the unit is probably bad, were you referring to the thermostat or the HVAC ? If it is the thermostat (the model number is discontinued), can I replace it with a NEST thermostat?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #4

    Apr 21, 2017, 08:37 PM
    Thermostat is likely the culprit. You need to go to the Nest website and check interchange. Simple test, with power off, remove the thermostat face. Move switch to AC. Connect the red and white wires. Turn power on. Does unit start?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell RTH7000 thermostat problem [ 0 Answers ]

I have a new Honeywell RTH7500 programmable Tstat, fan will run in continuous fan mode but not in fan auto mode?? Have programmed it for the auto mode but still no fan there.

Problem with Honeywell RTH2300 thermostat [ 0 Answers ]

Hello, I installed a new HOneywell thermostat in my house, heat only (2 wires: R & W). The thermostat is kicking the furnace/fan on for 10 second intervals, with 10 seconds in between, over the course of half an hour (usually when transitioning from cold to warm modes. i.g. leave to return). ...

Problem with Honeywell RTH230B thermostat [ 20 Answers ]

Hi, I have hooked up the thermostat (replaced an old analog Honeywell unit) and had the same wiring as the one on this post https://www.askmehelpdesk.com/...ead.php?t=14531 (ie on the old unit, the blue wire to the Y terminal and a yellow jumper wire from the Y terminal the back of the unit -...

Problem with New Honeywell RTH6300B Thermostat [ 5 Answers ]

We have a Frigidaire model B3BM-024K-A HVAC system. It is all electric. A few days ago, my husband replaced the old thermostat with a Honeywell RTH6300B programmable one. My husband wired it according to the instruction. It has a problem: the heat will not switch off automatically when the...

View more questions Search