Ask Experts Questions for FREE Help !
Ask
    ca_surfer's Avatar
    ca_surfer Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 17, 2009, 04:09 PM
    Honeywell T8001 bad dispay.shows all the symbols does not show temp/time
    We had a power failure for couple of seconds two times in one night and I noticed the display of my honeywell T8001 was not showing the temp/time and was showing all possible symbols that can be displayed on it. I thought it is dammaged but when moving to fan it works but does not show anything on display. Please advise.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Jan 17, 2009, 05:36 PM

    Not a lot you can do here. I would try replacing batteries first. If this doesn't help, I think you may need a new thermostat. How old is it, it may be under warranty. If fairly new, take it back where you got it and see if they will replace.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

94 Toyota 4x4 truck temp gauge shows hot [ 2 Answers ]

When I start the engine, after a few minutes the temp gauge goes directly to the hot side. The engine is not overheating. I changed the temp. gauge sensor but that made no difference. I doubt the temp. gauge sensor wire is grounding because if it was, the gauge would immediately go to the hot side....

Honeywell thermostat shows F and/or 8 [ 2 Answers ]

Hi all, I have an Honeywell thermostat (checked and looks like T8775C Round Thermostat) that yesterday start to show F or 8, changing from F to 8 in a second and back. I reseted the heating central but after a while it goes back to 8/F. Does anyone know what should I do except calling for...

Honeywell T8001 thermostat goes blank [ 2 Answers ]

I have a 5 hear old dual zone Heat/AC system with two Honeywell T8001 thermostats. These units don't use a battery. About once a year one of the T8001s goes blank. Since the T8001 clips to a bracket on the wall, I mobilized my advanced troubleshooting skills and simply swapped the units. The...

Honeywell T8001 Thermostat - Blank Display [ 1 Answers ]

Kids while playing in the backyard were banging against the outside compressor unit and I found later that the display on the thermostat is now blank. So I can not switch on heating or air conditioning. Since my house has two units one for upstairs and one for downstairs, I tested by swapping the...

Honeywell RTH 7400 ?temp. Diff. Setting [ 3 Answers ]

:cool: I installed a Honeywell RTH7400 therm. Today and my heatpump is continuesly cycling on, is there any way to change the temperature differential setting on this unit

View more questions Search