Ask Experts Questions for FREE Help !
Ask
    khopper07's Avatar
    khopper07 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 4, 2016, 07:05 PM
    Need help Changing current Tempature display
    We have a Maple Chase Thermostat 9610. The current temperature display says 36 and bounces to 92. I don't know how to change it so it reads correctly. It will let me change the temperature setting to F or C but not the current temp.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Apr 4, 2016, 07:21 PM
    This should help, start on page 5 https://villagesatbelvoir.com/wp-con...96df8b0385.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lukewarm tempature [ 2 Answers ]

I inherited my Aunts House which was built in 1922 over the summer had the bathroom remodeled,which was totally gutted and we just have a stand up shoer,not tub .We were getting hot water until recent now just lukewarm when faucet turned on hot.We also replaced hot water tank few months ago.It is...

Tempature will not reach its setting [ 1 Answers ]

In the morning my heat will not reach the temp setting of 73. It will cut off at 68. In the evening it will reach the temp setting of 73. The furnace and heat setting device is only 2 years old. I do not understand why it works in the evening but not in the morning. Any ideals

Adjust tempature on luxpro thermostat [ 0 Answers ]

My themostat on luxpro will not adjust for cool air

Tempature gauge [ 1 Answers ]

My 2003 explorer just started overheating well at least the temp gauge says that. It doesn't blow hot air either. I do not know what's wrong I. Replaced the thermostat and that didn't work. It will run fine then out of the blue it will go to overheating but when I stop and check everything it...

Can't boot after changing display from PCI to AGP in CMOS [ 22 Answers ]

Hi: I was trying to install ATI ALL-IN-WONDER PRO card into my old PII Win98 SE, but can't install display driver. So I accidentally changed CMOS display from PCI to AGP. The computer won't boot anymore, and I don't have AGP slot in my motherboard. Moniter only showed "no signal input". How can I...

View more questions Search