I have an intertherm mod # E2EB-015HA.

bibillings Posts: 1, Reputation: 1

New Member

Jan 17, 2014, 12:50 PM

I have an intertherm mod # E2EB-015HA.

The heater elements both come on, but the blower will not come on in the auto position. It does, however, come on full blast in the on position, blowing warm air.

Check out some similar questions!

Can I oil my intertherm blower motor 2002 e2eb 015ha [ 0 Answers ]

Can I oil my intertherm blower motor 2002 e2eb 015ha

I need a manual for 2002 intertherm e2eb 015ha [ 0 Answers ]

Can I oil my intertherm blower motor 2002 e2eb 015ha

Nordyne model e2eb-015ha wiring diagram [ 0 Answers ]

Where can I get the wiring schematic for this particular model Nordyne unit ? My indoor blower is coming on when the breaker is turned on but the thermostat is not calling for it . When I disconnect the green wire from the thermostat it turns off . Thank You

E2eb-015ha [ 0 Answers ]

My furnace has been acting up for some time. The coils will heat up but the fan, in the auto mode, won't kick on. I can put the fan in the fan only and it will run. I have replaced all 3 relays in the furnace. I have replaced the thermostat and the cap on the motor. It still does the same thing. It...

My Intertherm heat pump furnace will not kick on Model no. E2EB-015HA [ 0 Answers ]

A few days ago the heat would not kick on so we turned it off and on at the thermostat a few times and it finally kicked on and worked fine for about a day. Then the same thing happened again. We then did the same thing by turning the thermostat up and down until it finally kicked on. The next day...

View more questions Search

Check out some similar questions!

Add your answer here.