 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Have a GMP 0753, keeps blowing the fuse
I have a GMP0753 , the ac side runs okay. The heater side dose not, it will blow the fuse, have replaced the main board, and the pressure switch, have step by step verifed the hook up per the supplied print, NOTE pressure switch not in cir unit will run by passing (same) gasvalve will operate.. is the safety side designed to trip the fuse, and if so how do I determin which ros is bad.. please advise... thanks ken
|
||||
Check out some similar questions!
I have an HK42FZ004 cercuit board. The fuse started blowing every so often after I resoldered two resistors with cracked solders. The fuse noe blows as soon as I replace it and turn on the power. I cannot figure out where the problem is. Please help
Hello everyone, I have an issue with my furnace. It just recently started happening, when running the ac the unit gets to the set temperature and then the unit clicks as if where going off and clicks again and keeps running. I looked inside and didn't see the status light blink.. Any help here?
I am not sure what is happening, We have two units the upstairs is running just fine. Now the downstairs keep blowing the fuse in the furnace. What it does is that it will let the fan run but when I reduce the temp. so the a/c will come on it blow the fuse. Thanks, George
I had an earlier post about neither the furnace or a/c working... well the problem was a blown fuse, and I have no idea why I didn't find it earlier. Anyway, I replaced the fuse and the furnace heat now works, but when I go to the a/c, the fuse blows every time. My furnace takes a little 5 amp buss...
1998 Dodge Ram, been sitting for about a week, went to turn on windshield wipers and they didn't work. Check the fuse and it was blown. Changed fuse and as soon as I put it in the fuse blows. Did this several times and no luck. ANY IDEAS! THANKS,
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
