Ask Experts Questions for FREE Help !
Ask
    DataJunkies's Avatar
    DataJunkies Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 26, 2011, 12:52 PM
    On my Goodman GMP050 furnace, how do I read and interpret an error code?
    On my Goodman GMP050 furnace, how do I read and interpret an error code?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 26, 2011, 05:09 PM
    By looking at the paper pasted to the inside of door/cover that covers the end where the blower motor is located
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My Goodman GMP050 furnace's igniter won't shut off after the furnace cycles. Why? [ 0 Answers ]

On my 15 yr old Goodman GMP050, the preigniter stays hot orange even after the furnace cycles properly. I've sanded the flame sensor and the igniter but it still stays on till I shut off the electricity at the furnace. Any thoughts? It's COOOOOOLLLLLLDDDDDDDDD!

Goodman gmp050-3 Burner Shuts Off before heating [ 3 Answers ]

The furnace control board went bad and has been replaced. The new issue... it will not stay burning through a heating cycle: 1. thermostat calls for heat. 2 induced draft blower starts. 3 ignitor activates. 4 audible click, gas introduced with light off... burns for 1-2 seconds(indoor blower begins...

Need help with a goodman furance gmp050-3 [ 1 Answers ]

It is goodman gmp050-3. the red light blinks 3 times. I have replaced the pressure control switch and the thermostat. But still no change. Could I have gotten a bad pressure control switch. What else could it be? HELP

Open rollout error code in 2 yr old Goodman furnace,but rollout tests good [ 5 Answers ]

Vgftft

Goodman Gas Furnace - LED flashing "2" error code [ 11 Answers ]

I have a 5 year old Goodman PGB024075-1A gas furnace. The LED is flashing a "2" error code, meaning an open end switch. I'm attempting to track down the potential causes of this error. After taking things apart, I found and removed an insect nest (the dirt clog kind) which had found its way into...

View more questions Search