Ask Experts Questions for FREE Help !
Ask
    Derryn's Avatar
    Derryn Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 31, 2013, 07:05 PM
    Goodman Furnace Troubleshooting
    I have a Goodman furnace that was not coming on, I replaced the pressure switch and the problem is still not fixed however I can get the furnace to ignite if I suck on the pressure switch hose, what could be the problem
    Thanks Derryn
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Feb 1, 2013, 05:15 PM
    Don't suck on the pressure switch. You can damage it. Take the hose off the venter motor & clean out the port where the hose attaches.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace troubleshooting? [ 2 Answers ]

I have a goodman furnace everything works fine until the blower tries to come on and it will not turn, but if I turn it by hand it runs. Is there a fix for this

Goodman furnace troubleshooting? [ 0 Answers ]

I have a goodman mid efficiency furnace that was installed in my house in 2007. I have to clean the heat sensor in it about 2 to 3 times a year. I was told by a technician that this is normal for these furnaces. But even after I clean the sensor, the furnace still seems to run all the time (a...

Goodman Furnace Troubleshooting? [ 3 Answers ]

How can you tell if your heat exchanger is bad? I am getting high Co2 reading. And the flames seems to be blowing to strong, or could that be the gas valve, or dose it need adjustment in the tudes? I don't think the chinney is plugged.

Troubleshooting goodman furnace [ 1 Answers ]

The flame sensor keep burning out and only run for a couple of minute . Maybe the condensation trap is fully of dirt

Goodman furnace troubleshooting [ 2 Answers ]

I went away for a couple of days and returned to a cold house. I have a Goodman Model HCC075ND4R that has Electronic Ignition with Relay + VR80204 - S8600H Control. I can not get it to fully ignite. It tries to ignite over and over again. I see a single blue flame for a short time, but not main...

View more questions Search