Ask Experts Questions for FREE Help !
Ask
    parttime1958's Avatar
    parttime1958 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 1, 2008, 12:48 PM
    Goodman furnace trouble codes
    I have a 5 year old goodman 92 that is giving me 5 blinks on the main circuit board. It goes through the start-up routine and after about three attempts the burners will stay on. What does that really mean?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 1, 2008, 02:07 PM
    Look on the inside of the door of the furnace. There will be a list of codes printed there.
    therinnaiguy's Avatar
    therinnaiguy Posts: 153, Reputation: 5
    Junior Member
     
    #3

    Jan 2, 2008, 08:58 AM
    Most likely you have a bad or dirty flame sensor. Also chek the wire from the circuit board to the sensor.
    tommyle03usa's Avatar
    tommyle03usa Posts: 1, Reputation: 1
    New Member
     
    #4

    Dec 26, 2010, 06:17 PM
    I have a 3 blink which is block open I don't know what it mean. Any help please
    Rich Saunders's Avatar
    Rich Saunders Posts: 1, Reputation: 1
    New Member
     
    #5

    Jan 24, 2013, 01:51 PM
    My goodman furnace starts but only lites once in awhile to only run for few minutes then the flame shuts off anf the fan blower just runs and the red led blinks 6 times then blinks another 6 times then again 6 times until I just shut it off. What could it be? I cleaned the flame sensor and had to replace the igniter becase it just it just crumbled in my hand. But still doesn't work right! Please help me out! My kids are freezing!!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 373LAV trouble codes [ 2 Answers ]

My Bryant 373LAV appears locked out. The trouble code is 3 short and 1 long. The trouble code sticker is missing from the blower door. Can anyone identify the code's meaning?

Anyone know the diagnostic codes for a goodman furnace? [ 3 Answers ]

Hi, I have an older model goodman furnace that powers up the vent fan and proceeds far enough in the sequence for the electric igniter to glow, but then never releases gas to complete ignition. I replaced the gas valve last year, so I am hoping it isn't this again. I am getting an error code on the...

Goodman Furnace - Won't Light, No Codes [ 3 Answers ]

Eleven year old Goodman gas furnace. The main vent blower will start, but that's where things end. The draft inducer motor doesn't start and nothing else in the chain obviously happens after that. The LED on the board stays red and never flashes any codes. I checked the voltage coming into...


View more questions Search