 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Getting failed igition signal on furnace, intertherm?
I have a intertherm furnace and it will iginite and run for about 10mins then the flame goes off, when it tries to start back up it will give me a failed ignition switch alarm.I replace the inducer motor less then a yr ago. When it runs, briefly the flame signal is low.Any suggestions...
|
||||
Check out some similar questions!
Furnace will run for 30 seconds. It shuts down and the yellow light will flash 6 times and the does the same thing over and over. Red light stays steady. Thanks for the help.
I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.
I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...
I have just in the last month had an Intertherm furnace installed, and since installation they have had to come in twice because they claim the starter button is not firing. They replaced it and now it is on the fritz again. It starts for about 8 seconds and cuts out. There is fuel in the tank....
I own a 1985 modular home and the intertherm blower fan on my furnace quit working is it too hard to fix or change?:confused: Also what is the cost to fix it?:eek: Please help!! :) Thank you Rachell
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
