Ask Experts Questions for FREE Help !
Ask
    jshorb's Avatar
    jshorb Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 1, 2013, 10:45 AM
    Gas Furnace Troubleshooting
    Have a Concord furnace that's 17 yrs old. The induction motor will cycle through but no spark to igniter or any smell of gas? Any ideas? Is there fuses or resets somewhere. This unit is outside it's a RPG12A42D100A-1A condord unit built in 4/96
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Feb 1, 2013, 04:56 PM
    Any light on the control board blinking? If so count the blinks then look on the control or inside the blower door for the key to the blink code.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York gas furnace troubleshooting? [ 8 Answers ]

My furnace is 15 years old I tried to turn it on today and the ignitor never heated up nor did gas ever flow to the unit. I tested the ignitor and it works what could the problem be?

Troubleshooting Gas Furnace Burners [ 1 Answers ]

I am looking after a house that has a model 230WG Bryant gas boiler. It may have a millivolt system as it is quite old. The pilot light is out. I can get the pilot light to start by holding the "set" lever, but as soon as I release it, the pilot light goes out. The owner of the house is...

Coleman gas furnace troubleshooting? [ 0 Answers ]

Coleman gas furnace model#DGAA077BDTA having multiple trouble codes flash, but here's what its doing; system works fine self ignitor switches on the gas switch clicks on the gas ignites stays on for about 40-60 seconds then gas switch clicks off flame goes out fan stays on code flashes 4 then 6...

Troubleshooting a gas furnace [ 0 Answers ]

I have a Trane XL80 furnace,the igniter is at one end and the flame sensor at the other. When the thermistat asks for heat,the fan kicks in the igniter glows then you here a click an you see the burners go on. My problem is sometimes it doesn't come back on, I watch to see if I can pin point...

View more questions Search