Ask Experts Questions for FREE Help !
Ask
    Atocha4's Avatar
    Atocha4 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 6, 2010, 01:34 PM
    Gas furnace, fan works, but no flame
    I have a gas furnace. House is 55 degrees. Thermostat is set at 80 degrees, switch on furnace is in on position and fan/blower works, Gas is present in hot water heater 24": away on same line and stove works in kitchen. Breakers are OK.

    Furnace does not light. No gas smell. Help!!

    Thanks
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Mar 6, 2010, 01:45 PM
    Could be gas valve,, could be limit switch, could be pressure switch, could be igniter, could be several other things,, u need to watch closely more info needed, tell us after looking up close what's not working
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
    		  
    #3

    Mar 6, 2010, 08:46 PM
    Do you have a pilot or electronic ignition?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas furnace - no flame [ 4 Answers ]

Hope someone out there can help, because it's going to get cold this weekend! I have a split HVAC unit with furnace in attic. Written on front of unit is Intertherm. Inside panel of unit says Nordyne, and the Ignition Control is Robert Shaw. The unit is 13 years old and the heat worked fine...

Comfortmaker gas furnace: LOTS of fan, no flame. [ 5 Answers ]

I have a Comfortmaker gas furnace from 2001. Model N9MP1050B12A1. Type FSP. Yesterday morning I noticed the fan didn't stop shortly after the usual heat cycle. I went out to the garage to investigate, & found what I'll call the PVC water outlet line frozen thanks to our new Arctic reality in N.C....

Furnace blower will not stop after flame goes out on gas furnace [ 1 Answers ]

Furnace blower will not stop after flame goes out on a gas furnace

Gas Furnace / AC unit fan works. Heat/AC do not [ 2 Answers ]

This winter the furnace control board in my Lennox Gas Furnace / AC unit failed and I had it replaced by a contractor. The contractor mis-wired the thermostat inputs to the board. He wired the Green (fan) wire to the C (compressor connection) board input and the C wire to the Green (fan) board...

View more questions Search