Ask Experts Questions for FREE Help !
Ask
    frankr's Avatar
    frankr Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 30, 2008, 12:19 PM
    Furnace gas valve shuts off after unit is runnig won't restart
    Furnace is a utica standing pilot gas unit I replaced the themocouple the boiler fired up. It seemed to be working but after running for awhile the gas valve shuts off and the boiler won't come back on. If I shut the gas turn off the pilot and relight the pilot the furnace kicks back on
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #2

    Jan 30, 2008, 04:54 PM
    Gas valve is probably going bad.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gravity furnace gas valve [ 3 Answers ]

Have an old gravity furnace. Pilot generator putting out 575 mv, however gas valve won't open (ITT General Controls B60 gas valve). How do I troubleshoot valve? What external or internal checks? I have the valve head off and looking under the diaphragm I don't see anything obvious. I'm not...

Furnace blower/ gas valve issue [ 1 Answers ]

Hello everyone! This morning before I hopped in the shower, I bumped the temp in the house up from 62 to 67. Well the furnace went through it's normal procedures and I noticed the blower turned off very quickly and I can hear the igniter trying to light the burners again. Well, not thinking...

Replaced Gas Valve, Central Air Heater won't start when its cold out [ 6 Answers ]

Each year when it gets cold, my Gas Air Conditioner won't start when its to cold out. I turn the thermostat up, the unit clicks but then doesn't start right away. Sometimes it won't start until the sun hits the air conditioner. Last year I replaced the valve and cleaned the flame sensor. From...

Replacement of a gas valve in a goodman furnace [ 1 Answers ]

I am replacing a valve in a 10 year old goodman furnace. The old valve has an orange lead in going to the "m" terminal and blue and green leads going to the "c" terminalfor a total of three leads . The new valve only has two terminals . How can I connect the new valve thomdunkneedshelp


View more questions Search