Ask Experts Questions for FREE Help !
Ask
    memphistn's Avatar
    memphistn Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 11, 2011, 04:14 PM
    Flame sensor failure
    Why is there no voltage going to flame sensor from smart valve? Flame dies after 2-3 seconds,even with new flame sensor; press.sw and roll-out limit are OK. Md#cg90ua100d16c-1a
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    May 13, 2011, 07:15 PM
    Flame sensor will not have voltage going to it. Sounds like you have a bad smart valve. Get ready to spend some $$$
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Flame sensor [ 3 Answers ]

Need to clean flame sensor on Amana 80 Command. Where is the flame sensor? How should I "clean" it?

What does the flame sensor look like [ 3 Answers ]

What does the flame sensor look like and where is it located?

Flame Sensor [ 2 Answers ]

I have a RHEEM furnace with a hot surface ignitor. The flame sensor will only register .01 microamps, not enough to keep the burners fired. What is the procedure for checking polarity for the furnace, and what could other possible causes be? The flame sensor is new, and the gas pressure is 3.5...

Flame sensor [ 1 Answers ]

I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.

Flame Sensor [ 5 Answers ]

How can I replace a flame sensor in a Trane heating unit?

View more questions Search