Ask Experts Questions for FREE Help !
Ask
    ccwhog's Avatar
    ccwhog Posts: 2, Reputation: 1
    New Member
     
    #1

    Aug 24, 2011, 02:36 PM
    Fan runs only with continuous switch thrown on EB15A Furnace
    The blower fan will only run when the Continuous switch is thrown.
    And not under Auto/ On setting of the thermostat. Would this be an issue with the Sequencer or the Control Circuit Board?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Aug 24, 2011, 05:15 PM
    Could be either. You will need to use a volt meter to see where you are losing power to the blower motor controls.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace Fan Runs Continually and Randomly [ 4 Answers ]

Chronological Sequence of Events 1.Programmable Thermostat installed in 2007, and was working as programmed 2.New Brock Furnace installed in April of 2009. 3.Furnace has run randomly as if it has a mind of its own, since the installation 4.Sometimes the air is heated and sometimes not...

Trane 5000 fan on unit inside home runs even with switch in off position [ 1 Answers ]

I have a trane 5000 unit that operates well, however, on the walll switch, you cannot turn of the fan and it runs if the unit is on whether on off or auto position. I have to turn off fan at awitch inside home.

Furnace fan only runs for 30 seconds [ 5 Answers ]

I have a gas furnace in our home. Recently the furnace gas preheats and the fan comes on but only will run for 30 seconds, when the gas reignites the fan turns off. I changed the filter but that made no difference. I looked at the fuses and while looking discovered the that the hot and common wire...

Lennox furnace fan runs on forever [ 1 Answers ]

I have a 10 year old Lennox conservator II forced hot air gas furnace, the furnace itself runs good and produces heat , the problem I have is that the furnace cycle never ends it turns on produces heat then the firing stops the fan continues to run it cools down then before the fan cycle stops...

AC fan runs slow, but switch to heat fan runs normal [ 3 Answers ]

The other morning I came into the house and noticed the ac was not working. I turned off the breaker to the unit for a few minutes. Then turned it back on. Went to the thermostat pushed it over to auto and the fan came on but ran very slow. I them turned it off. Then turn on the heat, the fan...


View more questions Search