Ask Experts Questions for FREE Help !
Ask
    kansascookie's Avatar
    kansascookie Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 20, 2011, 01:49 PM
    Evcon troubleshooting?
    Booster motor will come on but will not light
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Oct 20, 2011, 02:57 PM
    Does it have electronic igniter? Is it trying to light,or glowing?if so can you hear the gas valve clicking or trying to open and let gas in?
    Let us know.
    Renee Anderson's Avatar
    Renee Anderson Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 21, 2013, 10:23 AM
    Quote Originally Posted by wmproop View Post
    does it have electronic igniter? is it trying to light,or glowing?if so can you hear the gas valve clicking or trying to open and let gas in?
    let us know.
    Yes It is only 2 years old
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace model no. DGU10014UB troubleshooting [ 11 Answers ]

Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(

Coleman evcon troubleshooting? [ 1 Answers ]

Our furnace is running, pumping warmish air. The thermostat is set at 68*, but our furnace doesn't seem to be able to heat our house over 61*. I've turned the thermostat and the furnace off and back on (the only troubleshooting I know!) with no results. It's a coleman evcon G FD024517A.

Coleman evcon furnace troubleshooting freezing inside coils [ 0 Answers ]

Coleman Evcon model number EB15B will only run on "Emergency" heat mode. Compressor froze over and coils are freezing.

Coleman evcon troubleshooting? [ 1 Answers ]

I have the coleman evcon electric furnace -- the blower works -- but doesn't put out much heat -- rather warm not hot - the unit may be in need of cleaning not sure -- or is there a part that may need replaced.

Evcon furnace troubleshooting free [ 3 Answers ]

Model# DGAA070BDTB It will ignite then shut off almost instantly then try to ignite again until blower motor comes on it then tries to ignite a few more times till it shuts off and shows a steady red blink. I have replaced flame rod sensor and checked limit switches for 24v all are OK. I replaced...

View more questions Search