Check out some similar questions!
Heater Shuts off Before Reaching Set Temperature
[ 5 Answers ]
I have a goodman a/c with electric heat strip (10kw) and vey recently it stated to turn off before reaching the set temperature. After a few minutes it will restart and run for a couple of minutes and then shut down again without reaching the setpoint. It always stops at 66 on the white rogers...
Draft inducer troubleshooting
[ 3 Answers ]
I have a 5 yr. old dunkirk xeb3 boiler. This year on starting I noticed a smell of burnt gas coming out from around the draft inducer housing. I checked housing and gasket, both seemed fine. Fan only runs for approx. 5 seconds before ignition, and shuts off right after flame stops. Could this be...
The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman.
[ 8 Answers ]
FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S
Temperature increases even after reaching programmed temperature
[ 3 Answers ]
I have a NOMA thermostat (model 52-2558-8). After reaching the programmed temperature, the furnace stays on without shutting down (8 degrees before I manually shut it off). Is this a thermostat issue or a furnace problem?
No voltage to my draft inducer
[ 3 Answers ]
I have a Janitrol Furnace that will not start up. I pulled of the tube from the draft inducer to the pressure switch. I sucked on the tube and the furnace fired up. So I checked the voltage going to the draft inducer, it read only 6v ac. Where do I go from here? View more questions Search
Add your answer here.
|