Ask Experts Questions for FREE Help !
Ask
    neguru's Avatar
    neguru Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 25, 2010, 10:09 AM
    Diagnostic codes high Aux or limit switch open
    I have a 3DHB12N07501D York gas furnace and it is combined with a heat pump. I noticed the Gas furnace was not kicking in. So after poking around I found the light on the board was blinking 4 times. The panel says it's the high Aux or Spill limit is open. First off I do not know what High Aux would mean. I checked the switch. I am not an electrician but I learned you can use an ohm meter to check. So I tested a normal wall switch in the open and closed position and It seems the Furnace switch appears to be closed. I did buy a switch and I guess it will be a spare if this does not fix it. No sure what else to look at. Can anyone help. Thanks

Check out some similar questions!

Troubleshooting 4 flashing lights - open high temperature limit switch [ 7 Answers ]

Thanks for your input. I finally was able to reverse the wiring and got it squared away. While I was in the attic I thought I would replace the motor which drives the fly wheel. I thought I was a hero till I put everything together and discover 4 flashing lights. The lights indicate "open high...

Spill or Aux Limit switch [ 9 Answers ]

My York Diamond 80 is not heating. When I turn it on the fan starts but flame does not attempt to ignite. The diagnostic code flashes 4 times. Sheet says 'Aux. Or Spill Limit switch' What are these? Where are they? Can they be reset?

Diagnostic light 4 open high limit device [ 1 Answers ]

My funace reads 4 what dose open high limit device mean and how do I repair it TRANE

Trane xe 80 open high temperature limit switch [ 1 Answers ]

Furnace is about 13 years old... we just replaced the ignighter in it last night because it was running through all the steps to run except ignighting. It fired right up and ran for about 7-8 hours... now it won't ignite at all (it is running through all the steps it needs to except for...

Diagnostic lights indicate pressure switch open because of reduced flow [ 1 Answers ]

My Carrier furnace is not starting for the first time this fall. The Diagnostic lights indicate pressure switch open because of reduced flow. Is there a re-set switch or some way to diagnose this problem. Is it possible there is something blocking flow? What can I do with this? In researching...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.