Correct flow of suction line drier location on condenser unit?

Check out some similar questions!

What should I check if liquid line is cold and suction line is warm? [ 4 Answers ]

The unit was installed 3 years ago. It was never started until now. I have changed the filter dryer, vacumed, and I opened the txv inside the cased coil. I have sucked the refrigerant back, and vacumed 3-4 times, but the liquid line stays cold and the suction line stays warm. I do know the...

Do you need to put in a liquid line drier if there was a leak from a crack [ 0 Answers ]

I am working on a carrier heat pump that has a common fault which is the discharge line cracks at a bend just outside the compressor. I usually bend up a new piece and install a vibration eliminator inside the unit to fix the leak and install a liquid line drier just outside the unit. The problem...

Matching up the correct capacitor with the correct condenser fan motor? [ 4 Answers ]

How crucial is it to match the right capacitor to the right condenser fan motor? If you have the wrong capacitor, can this cause the motor to stop after running for a while, say 20 or 40 minutes? It would start up again, but would allways stop. The specs for the motor are: Emerson E-line, model no...

Suction Line Sweating [ 3 Answers ]

I have been dealing with this problem for a while now not knowing it was the suction line all along. It started some time back with a tiny wet spot in a bedroom ceiling. I figured a roof leak and had repairs done. Some time after the roof repair a new wet spot next to the first one then some time...

View more questions Search

Check out some similar questions!

Add your answer here.