Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(
Add your answer here.
Check out some similar questions!
Coleman evcon furnace [ 5 Answers ]
My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...
Coleman Evcon electric furnace [ 2 Answers ]
I have a Coleman Evcon electric furnace in a mobile home I rent. Recently a wire had burned off which caused it to produce no heat. After they sent a repair man to work on it I now seem to not have as much air force coming out of the registers. Also it takes 20 minutes to raise the temperature one...
Blower during furnace operation on electric Coleman Evcon [ 2 Answers ]
I just installed a programmable thermostat for an electric Coleman Evcon furnace. Now when the furnace comes on the blower also comes on. Sometimes the blower goes off a minute or so before the furnace stops. It never did this before- in fact I didn't even know there was a blower. Do I need to...
Coleman Evcon electric furnace [ 1 Answers ]
How do I know or rather how can I check to see if the repairman cut off one of the heating elements and where are they located?
Centrifugal- Won't come on Coleman-Evcon Furnace- [ 2 Answers ]
Hi, Just found your site today-yipee! I have a problem with my Coleman-Evcon furnace (it has had A/C added)-just bought the house this year, but previous occupants said all was working before. When I turn on the heat on the thermostat, I get a code 3 readout, "Centrifugal Swithch Open"; I had...
View more questions Search