Ask Experts Questions for FREE Help !
Ask
    Rshaffer's Avatar
    Rshaffer Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 28, 2009, 07:05 AM
    Coleman/Evcon furnace don't know how to turn on fan
    I have a Coleman/Evcon furnace Mod #BGM08015C (No AC)

    I would like to just run the fan to circulate the air in the house.

    I can't figure out how to do this. Any help would be appreciatd.

    Thanks much!
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Jun 28, 2009, 09:02 AM

    Take the door off the furnace, look on the left side for a small black rocker switch. Should say on off and fan.
    Rshaffer's Avatar
    Rshaffer Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jun 28, 2009, 12:29 PM
    Take the door off the furnace, look on the left side for a small black rocker switch. Should say on off and fan.

    Thanks, I looked on the left side but don't see the switch. Is it on the motor?

    Thanks again.
    letmetellu's Avatar
    letmetellu Posts: 3,151, Reputation: 317
    Ultra Member
    		  
    #4

    Jun 28, 2009, 01:50 PM

    If you don't find the switch that he told you about then look at the fan and limit switch, some of them have a "fan on" switch on them.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace [ 4 Answers ]

Furnace will won't heat. Model #BGMO7516B Serial # 980905038. Red light blinks once. Will ignite but won't kick in to heat.

Coleman evcon furnace [ 5 Answers ]

My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...

Coleman Evcon Furnace [ 1 Answers ]

We have a Coleman Evcon DLAS075BDD furnace which keeps displaying error codes: 1-Ignition Failure and 4-Limit cycling. We have replaced the circuit board. Inspected the ignitor and the flame sensor and both appear good. Also have taken the exhaust vent/hood off and vaccuumed out any rust to...

Coleman evcon oil furnace [ 8 Answers ]

I have an older coleman evcon oil furnace that ran fine until today.It still runs but the smoke exiting the chimney is pure black and sooty. Would this be an indication it's not getting enough air or maybe getting too much oil? Don't have any experience with oil furnaces. Thanks, Ken

Coleman evcon furnace [ 1 Answers ]

I have a coleman evcon direct vent forced air furnace, the air is blowing cool air, everythinig else is working it's firing ,the fan is working

View more questions Search