Check out some similar questions!
2 flashes armstrong gas pack circuit board. Is this the flame sensor?
[ 9 Answers ]
Armstrong gas pack flashes twice when flame shuts down. Is this the flame sensor?
Hello there! I cleaned the flame sensor
[ 0 Answers ]
Hello there I cleaned the flame sensor now the furnace won’t start at all, is there anything else I can do before I call the serviceman? Thanks My furnace keeps turning on and off every minute. The flam comes on and than you can here a puff, than it shuts off. Keeps repeating over and over...
Trane xc90 gas heat lights then goes off, have changed flame sensor
[ 36 Answers ]
I have changed all of the sensors and then I thought it was fixed. It ran and stayed lit for about 30 min and then went right back to the same problem. It will light and then the gas shuts off after a few seconds. If I let it cycle through this 3 times and then it should go to the " lock out"...
Flame sensor day and night 394 gas furnace
[ 4 Answers ]
Hi, My 20 year old day and night model 394jaz036065 lights the pilot and after awhile fires the burners then shuts down. Now it just lights the pilot and then shuts the pilot down after a while 2+ minutes. Is the flame sensor mounted to the ignition/pilot assembly? I am trying to confirm that-...
Flame sensor
[ 3 Answers ]
Need to clean flame sensor on Amana 80 Command. Where is the flame sensor? How should I "clean" it? View more questions Search
Add your answer here.
|