Ask Experts Questions for FREE Help !
Ask
    Kenny43's Avatar
    Kenny43 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 28, 2010, 08:01 PM
    Circit Board or Flame Senser
    Furnace runs it cycle but drops the flame.

Check out some similar questions!

2 flashes armstrong gas pack circuit board. Is this the flame sensor? [ 9 Answers ]

Armstrong gas pack flashes twice when flame shuts down. Is this the flame sensor?

How do you check a distributor senser and where are they [ 0 Answers ]

How do you test the sensors inside the distributor of a 95 honda civic ex

Beckett burner starts has flame for about 15 seconds off for 12 then flame on & runs [ 7 Answers ]

I have replaced the following with the problem still happening: replaced the primary control(R8184G 4009), cad cell--the oil unit was service at the beginning of the heating season. Ran like a champ. Now for the past two weeks with new parts the problem is: Oil burner starts with a flame for...

The Ok light is flashing, the Flame light is off in the furnace circuit board [ 0 Answers ]

I have a Ruud Silhouette II Gas Furnace. The whole unit is turned off/on by a light like switch. The AC is working, but the heater is not. It appears that no gas is flowing to the burner. The PWR light is on, steady. The OK light is flashing; three times on, then off. The Flame light is off in...

Cleaning a flame senser with a dollar bill? [ 8 Answers ]

Just want some fact on cleaning flame sensers. Our local gas company has taken it upon themselves to try trouble shooting gas furnaces. I have gone to many homes after the gas guy has been there and all I had to do was clean the flame senser(correctly I believe). I always use emory cloth to...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.