Ask Experts Questions for FREE Help !
Ask
    poohbear404's Avatar
    poohbear404 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 22, 2008, 03:06 PM
    Carrier furnace short cycles
    I have a carrier furnace and when I switch to heat on the tstat the inducer fan comes on then the burners ignite then the blower motor comes on, after about 45 seconds or so the blower motor and burners cut off but the inducer fan keeps running and this process starts again in 10 to 15 minutes with the inducer fan never cutting off what could be the problem
    NorthernHeat's Avatar
    NorthernHeat Posts: 1,455, Reputation: 132
    Ultra Member
     
    #2

    Jan 22, 2008, 03:36 PM
    Weak main limit, poor airflow, dirty filter or evaporator coil or insufficient supply and/or return air.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm Furnace Cycles Off and On [ 8 Answers ]

Have a Intertherm furnace in my mobile home that is about 10 years old and has worked fine until last year. It will cycle the blower off and on a couple times during the warming cycle until it reaches a certain temp in the house. If it is above a certain temp in the house it runs fine and works...

My Carrier HP cycles at night [ 3 Answers ]

I have a new Carrier 25HBR 13 Seer 1.5 ton heat pump and in the heating mode when the outside air is below 35, the unit cycles like crazy. Keeps me up at night. Is this correct? I have tried two different thermostats with the same result.

Short Furnace Running Cycles [ 7 Answers ]

My furnace only runs for 15-30 seconds at a time. It will kick off and then fire up 2 minutes later for about another 30-40 seconds. The desired temperature is maintained but the very short on and off cycles are very annoying. We were told it may be our thermostat so we installed a new one and we...

Furance short cycles [ 2 Answers ]

I have a carrier 8000 furnace model#58ZAV050-08-serial#3395A20997. In the past ten days the furnace cycles through and run for a while then shuts down.I'm not getting any LED codes. The flame sensor looks good, the high pressure switchseems OK,no indication of a cracked exchanger the flames in...

Furnace heat cycles on/off [ 1 Answers ]

We have an old furnace,not quite sure how old.It is a Bryant Quietair.I noticed tonight the burners would light,stay lit for a few seconds(30-40secs.),then go out,and then relight a few seconds later.The fan is running throughout the whole process like it should.This goes on constantly.What is...


View more questions Search