 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier furnace 58mvb led diagnostics
The orange status light blinks fast indicating reversed polarity. But when I change the polarity it does not stop blinking the code. I checked the breaker panel for correct wiring the receptacle is good. Transformer and inducer motor are connected correctly to the board. Could I have a bad primary board.
|
||||
Check out some similar questions!
I have a Goodman Furnace Model GMPN060-3. I get three blinks biagnostic code. I changed venter (motor assembly) and pressure switch. Still the same three blinks. Moisture drain path is clean and free of debries. After the new parts, furnace started once, but would not start again -- same three...
Have a carrier furnace and blower is staying on and led code 33 shows up, replaced filter and still same issue? Any help
I cannot find the "name" of my furnace, but it is a Carrier CK5BXWO48024AAAA. It is gas. We bought the house (built in 2001) from someone who didn't provide a manual. Early Dec, the blower is running nearly constantly, but the temp never gets above 66. So, I went down there, and it is...
I have an Intertherm Furnace in a mobile home that I own and rent out. The furnace has a self diagnostic capability and shuts down periondically. The indicator lamp(red light) flashes in a series of four (4) flashes after it has shut down. I can reset it very easily by turning off and back on the...
... not sure why? I was troubleshooting an obvious ignitor failure on my Carrier furnace due to lack of heat, but while trying to create a cycle with another heat source it seems I've grounded out something causing a nice electrical pop, thus giving me a failure "refer to twinning kit...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
