 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier 58STA090 gass furnace not working
Furnace isn't heating. 120vac power to Furnace is OK. LED light is blinking a code of 31. I can hear the blower on the bottom. Thermostat batteries and signal to unit is good. I shut down the power to the unit for a few seconds then power on.. it goes through the startup sequence and has the same code. Not sure how to tell if the pressure switch is bad or the inducer (I think the inducer might be the problem). I do not hear gas ignition when the thermostat is turned up but I can hear the click. I do not smell any gas.
|
||||
Check out some similar questions!
Error code 14 is displaying. When I turn off power and turn it back on the furnace ignites, all burners light and furnace heats until thermostate desired temperature is reached. I cleaned the flame senser with steel wool. The furnace works okay for a time or two again then repeats the error code...
I have a Carrier 58STA090-16 furnace that doesn't stay on. I have a power switch next to the furnace and I can turn it off, then turn it back on and the furnace will start and run for a while (like 8 hours), then it goes stops running until I go down and reset the power switch again. Any ideas?
The fan runs all the time and the pilot light is out, tried total power shut down and still no pilot light and as soon as it gets power the fan kicks on and runs non stop? Please someone tell me how to fix or what's wrong, its getting cold in here... :):):)
Recently my Carrier 58STA090-16 furnace stopped working. I cannot figure out what is causing the problem. Here is what I have checked so far with no resolution: :confused: :mad: Checked breaker box in garage - no fuses tripped, did a reset anyway Checked all GFI outlets throughout...
Carrier furnace cover needed. Asap how do I find one
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
