 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
C my coleman presidential II blower works but no heat unless set at a high temp
With thermostat set at 65 the blower will start without any heat then blower shuts off after 1 minute. After 15 minutes repeats the same procedure. But if I set the thermostat at 75 plus the heaterthe blower will start and after a minute or two warm air will be delivered.
Could this be the lower seqence switch is bad or the lowest elememt is. |
||||
Check out some similar questions!
I recently purchased a mobile home and know nothing about maintaining it. The weather is turning cold and I do not know how to make my furnace work. I turn the thermostat to heat and set the temp but nothing happens. I checked it and the pilot light is lite and stays on, but, the furnace does...
This Electric furnace will only function in the heat position. The fan will not operate as fan only. The cooling doesn't start. I changed the thermostat, relay switch (R8222 D 1014), sequencer (R8330 D 1039) checked for continuity in the thermostat wires I hope you can help
I live in an older mobile home and have a coleman presidential II furnace. When I turn it on, the pilot is lit and it produces heat, but the blower is very loud like banging. The impeller (?) the round thing that spins seems to be hitting the sides. There is nothing holding it to the shaft. The air...
Coleman evcon presidential furnace... heat runs but doesn't get to temp set on thermostat... ie. Thermostat is set at 71 and only runs to 66 then starts cool down faze. Restarts within muntes and sometimes during cool down faze
I have a Coleman Pres. 2 electric furnace(20KW) mdl#3120-751.The blower will only run @ slow speed and will not run @ high after warm up. The heat strips are clean and seem to work as the unit produces heat but @ very low CFM. Not sure what and how to test.Any help appreciated!
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
