 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Burner and vent question
Weather maker 8000 model 58WAV070-12
I cleaned the flame sensor and replaced glow rod. All steps proceed as normal until the burners are lit. There are three and the first two stay burning but the third starts and then shuts down quickly. This is the one in front of the flame sensor. I have disassembled and cleaned out Each of the burners and the flame sensor. It worked for 24 hours then quit again and is doing the same thing. Is it something on the manifold that can be cleaned / replaced? 2nd question -looking at venting. It comes off top of furnace slopes upward connection with water heater and continues sloping upward to ceiling but is then blocked by subfloor at end. I know it's blocked cause I have removed all carpet from upstairs above it in prep for getting new flooring. It is under a hall closet. Should it be open? There is a lot of white crystallization on the vent that drips down onto and into furnace. |
||||
Check out some similar questions!
Does the vent of a bath drain have to be directly over the drain? Can I tap into an existing vent (sink drain vent approx 6 to 9 ft away)
I have a 80% LP furnace venting up through a double wall chimney through the roof. I want to install a wood burner in the basement next to my LP furnace. After installing the triple wall 6" for the wood burner, can the LP furnace vent on the new stack? If not, can the PL furnace vent outside on...
Hello all, I have a gas burner, which is about 30 years old. It still seems to run rather well. My question is... What should the temperature settings on the burner itself be set at during the winter season? Im looking for the most efficient setting. I have baseboard heating, and it...
I have recently purchased a home with a wood burner add on to the regular forced air heat pump my question is do I need to keep the blower constantly running on the back of the wood burner to circulate the warm or let the blower on my heat pump run to circulate the warm air from the wood burner...
When you flush tiolet or let water out of tub or sink, if the vent is working properly will it force air out of the vent?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
