 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant plus 90 furnace, second part to question #1
Everything works good and the LED light is solid, but as soon as it tries to ignite for the first time code 34 pops up, lights up for 2-3 seconds and then flame goes out and goes through the cycles and then shuts off. Ive check the condensation tubes and all are clear of any obstruction. I did some research and all came back to that flame sensor, is burnt out. I'm going to replace it and see what happens.
|
||||
Check out some similar questions!
Bryant 383kv won't light error code 14, what part do I replace
[ 7 Answers ]
The thermostat is calling for heat, 65 deg, the temperature is only 58 and furnace is in lock down showing error code 14. The furnace is a Bryant 383KAV. If I cycle the power to the furnace off and then on again, the furnace will start and run in a normal fashion. This has been happening more...
This is a multi part question.
[ 5 Answers ]
I am 40 years old, I got married to my wife at the age of 20. We dated since I was too young to drive. I never really had any girlfriends prior to her, dated a few but nothing I would consider serious. We were each others "first." Somewhere around the age of 25, we both mutually agreed to see...
Switch furnace to emergency mode on my Bryant 90 furnace
[ 2 Answers ]
I have run out of propane and we are in the middel of a blizzard. How can I switch my furnace to emergency mode? Thanks, Brett
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
