Ask Experts Questions for FREE Help !
Ask
    Lindehart's Avatar
    Lindehart Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 31, 2010, 07:31 AM
    Bryant Plus 80 / Model 330AAV Upflow Code 14 problem
    Getting a code 14.
    1st the system comes on. I hear the blower going for about 90 seconds.
    2nd the blower wheel spins and eventually I start to smell gas.
    The unit clicks 3 times but the ignitor never comes on. That's when I get a code 14.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 31, 2010, 08:10 AM
    Look on the back side of the blower motor access door for the legend/code and post exactly what the code means for your furnace.
    Lindehart's Avatar
    Lindehart Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jan 31, 2010, 08:19 AM
    14 Ignition Lockout - Control will auto-reset after three hours. Refer to #34.

    I tried sanding the flame proving sensor -- still not working. When I used to look at the furnace when it was running, I would see something glowing bright red -- I am not seeing that now.
    rick79's Avatar
    rick79 Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Jan 31, 2010, 10:28 AM

    Based on you not seeing the red glow, most likely your ignitor is burnt out.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace model 376cav, error code 24. [ 7 Answers ]

I am getting error code 24 on my bryant furnace. Could someone please help me by letting me know what the code is, and how to fix it? I was trying to install a new thermostat and might have got wires crossed. Thanks

Bryant 330AAV Code 34.every now and then. [ 2 Answers ]

Wanted to know if anyone could help me troubleshoot this problem.. This furnace will not fire up (every now and then), basically what happens is the igniter lights up, but will shut down after 5 seconds or so. It will do this three times until it goes into lock down, code 34 flashes. I reset...

Bryant Model 330AAV code 43 [ 1 Answers ]

I have a Bryant Model 330AAV Upflow- the flashing indicator lights say it could be a Pressure switch, Draft safeguard switch stuck, or low heat pressure. How do I determine what the problem is?

Bryant Model 330aav furnace Problems [ 8 Answers ]

Hi My furnace stopped working this morning. It's 8 degrees here in Michigan... brrrrr. :( I checked for an error code but the LED light was on continuous. The problem was that the furnace was on (flames going) but the fan would only stay on for about 2 minutes and then turn off. I had...

Bryant upflow furnace model394g lp [ 1 Answers ]

How do you adjust pilot light?

View more questions Search