Ask Experts Questions for FREE Help !
Ask
    rbspecht's Avatar
    rbspecht Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 13, 2009, 12:55 PM
    Bryant Plus 80 error 33
    Good Afternoon;

    I need some help to understand why I'm getting the error, and what I can do to fix it. Its -38 degrees C outside and the furnace is working really hard to keep up... but is unable to do so. Its shutting down the flame constantly... the temperature in the house has dropped to +18 degrees C. Any ideas of what I can do?

    Thanks!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Dec 13, 2009, 01:05 PM
    https://www.askmehelpdesk.com/heatin...-a-266589.html
    rbspecht's Avatar
    rbspecht Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 13, 2009, 02:06 PM
    Thank you for the link. I found the switch/reset. It doesn't give me a 'positive' lock on reset. Is this normal for the switch?

    The furnace is reacting differently now. It is in a 'burn for 1.5 minutes' and 'no burn for 2 (3) minutes' sequence. Is this normal?
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
     
    #4

    Dec 13, 2009, 02:52 PM
    Code 33 most commonly occurs as a result of overheating (see "SERVICE" label on front/blower panel). Check for cycling on main limit control, common symptom of an overheating condition.
    Attached Images
     

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Plus 80 Error code 33 [ 3 Answers ]

Hello! I'm new on here so bear with me. I found a similuar post on the Bryant 80 but I believe I have a different model... not sure how much that matters. The only model number I could find on the unit was CK5AXA036017AAAA The Error code is 33 Limit or flame roll out switch is open. The furnace...

Bryant Error Codes [ 1 Answers ]

Trying to find error codes for Bryant Furnace it's 7 years old (can't read the model #) I am getting 4 slow red flashes followed by 3 quick ones. Thanks for any help.

Bryant plus 80t error code 31 [ 7 Answers ]

Ok, the furnace stopped working this morning. Need some help. The flame goes on, but turns off after a minute. The LED flashing code on the motherboard says 3-1 (31 - which is the high heat pressure switch -- also says to refer to error code 32 which is the low heat pressure switch). I turned the...

Bryant plus 80 error code 31 [ 1 Answers ]

Bryant Plus 80 furnace - Error code 31 What are the corrective measures to put this furnace back to producing heat? There is power, the fan works but there is no heat. We lost power recently but it worked after that. Last evening there were high winds which were indicated on the code...

Error codes on bryant gas pac [ 1 Answers ]

This is for Northernheat ----- you told me to clean my flame sensor and so I did and also cleaned the place that it is attached and put a ground wire from the screw to the ground screw on the board post to make sure and I still get a code of 8 flashes that said it detected an error in the soft or...


View more questions Search