 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant Plus 80 Blower Problems: Error Code 13 and 33
I have a Bryant plus 80 furnace with the following symptoms.
Blower motor starts on low speed. Gas ignites Flame burns for about 90 seconds Relay in motherboard makes a clilcking sound. Fan does NOT kick into high speed. Furnace turns off Mother board produces error code 33. A reset on the blower door safety switch makes code 33 go away and displays error code 13 for three minutes then the process begins again. Any ideas why the motor does not kick into high speed? How do I get rid of error codes 33 and 13? Why does the furnace turn off after relay clicks and fan fails to spin on high? |
||||
Check out some similar questions!
Our heater is flashing an error code 33. The furnace turns on and off before getting up to the temperature that it is set at. The thermostat loses power completely when this happens, and when it comes back on the letters AC are showing on the display. It then shows the temp and the furnace kicks...
Hello! I'm new on here so bear with me. I found a similuar post on the Bryant 80 but I believe I have a different model... not sure how much that matters. The only model number I could find on the unit was CK5AXA036017AAAA The Error code is 33 Limit or flame roll out switch is open. The furnace...
I woke up this morning to no heat. I went down and started searching on the web for answers. I checked all the rubber hoses and they all seemed very clear and air tight. I found someone with the same furnace and same furnace. The tech told him to bypass the pressure switch. Before I did so, I...
I have the Bryant 352MAV 2-stage furnace that is giving me problems: When the thermostat is set below the target temperature i.e. 19C/68F the LED code indicator (on the logic board) is steady ON, once the target temperature is set i.e. 24C/78F , the inductor motor comes on for perhaps 15 sec, then...
Bryant Plus 80 furnace - Error code 31 What are the corrective measures to put this furnace back to producing heat? There is power, the fan works but there is no heat. We lost power recently but it worked after that. Last evening there were high winds which were indicated on the code...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
