Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant Furnace model 383KAV won't kick on
[ 10 Answers ]
I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...
Bryant furnace won't run looking for guidance to check
[ 2 Answers ]
I have a Bryant Furnace Model 383KAV042091 At the beginning of the summer the air conditioning would not come on so I installed a knew thermostat. It came right on. Now as winter approaches we switched to Heat and the furnace will not come on. The air conditioner works, when I flip the switch to...
Location of the flamer sensor in a Bryant Model 383K Furnace
[ 3 Answers ]
Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...
Bryant gas furnace won't light
[ 1 Answers ]
I have a Bryant gas furnace that won't light. It starts its normal cycle with the inducer turning on, then the gas but the gas never ignites. It will do this three times then stops.
Bryant gas heater model beginning 310aav
[ 3 Answers ]
I had not used my furnace over the summer. Before turning on the thermostat, I replaced the filter and checked to make sure red light was on solid. Turned on thermostat and furnace light started blinking error code 23, which according to list on furnace means pressure switch obstructed or off. I... View more questions Search
|