Ask Experts Questions for FREE Help !
Ask
    boviea's Avatar
    boviea Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 12, 2010, 07:50 PM
    Bryant furnace code 33
    Fan starts up but no heat. Code 33 comes up.. pressure switch problem. Is it the switch or is the sensor line clogged?

Check out some similar questions!

Bryant furnace error code 31 [ 3 Answers ]

I have a Bryant 350MAV048100 furnace. It runs for 15 minutes, cycles off and then cycles on and shows an error code 31. I've cleaned out the intake /exhaust lines, but still have the problem.

Bryant furnace code 24 [ 2 Answers ]

First there was a code 24, Ireplaced the fuse, fan works, but not lighting of the flames to produce heat. Any sugestions as to the next step>

Bryant 95 furnace with code 42 error [ 0 Answers ]

Less then a year old. I'm getting an intermittent 42 error. After turning the power back on to the unit it goes through its self check mode and goes back to a constant light, indicating no problems. Then a day or two later 42 again. Both intake and exhaust pipes are clear, new air filter. Any...

Bryant furnace fault code 14 [ 1 Answers ]

I have a13 year old Plus 80 Model 331AAA which will stop for no reason. Shows error code 14 when it stops. Furnace has been thoroughly checked twice in past two weeks by technicians and they can't find any reason for the unit to stop. If I turn off the power switch on the side of the unit for a few...

Bryant 395CA Furnace. Code 24. [ 1 Answers ]

I have a Bryant Furnace and I am getting Code 24. 3AMP Fuse is blown. The 120V to 24/40V transformer inside the unit is humming. With a meter I'm getting 20V off a lead, and 28V off another lead. If I disconnect the lead wire from the control board the fuse does not blow. Could this be a bad...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.