Ask Experts Questions for FREE Help !
Ask
    gus09's Avatar
    gus09 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 1, 2009, 10:34 AM
    Bryant furnace code 24
    First there was a code 24, Ireplaced the fuse, fan works, but not lighting of the flames to produce heat.
    Any sugestions as to the next step>
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 1, 2009, 01:05 PM
    Check for power being applied to the ignitor during the beginning of the burn cycle. You did not supply the exact model number.
    ACMike04's Avatar
    ACMike04 Posts: 10, Reputation: 1
    New Member
    		  
    #3

    Jan 2, 2011, 12:44 AM
    Check polarity on furnace some ingnitors will not heat up if wires are not right..
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace model 376cav, error code 24. [ 7 Answers ]

I am getting error code 24 on my bryant furnace. Could someone please help me by letting me know what the code is, and how to fix it? I was trying to install a new thermostat and might have got wires crossed. Thanks

Bryant 383KAV Furnace - Code 14 - Not getting 120 volts to ignitor [ 4 Answers ]

Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...

Bryant furnace error code 31 [ 3 Answers ]

I have a Bryant 350MAV048100 furnace. It runs for 15 minutes, cycles off and then cycles on and shows an error code 31. I've cleaned out the intake /exhaust lines, but still have the problem.

Bryant 395CA Furnace. Code 24. [ 1 Answers ]

I have a Bryant Furnace and I am getting Code 24. 3AMP Fuse is blown. The 120V to 24/40V transformer inside the unit is humming. With a meter I'm getting 20V off a lead, and 28V off another lead. If I disconnect the lead wire from the control board the fuse does not blow. Could this be a bad...

383KAV Bryant Furnace - Code 14 Not getting 120 volts to ignitor [ 1 Answers ]

Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...

View more questions Search