Ask Experts Questions for FREE Help !
Ask
    Gjazzworks's Avatar
    Gjazzworks Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Oct 9, 2011, 12:12 PM
    Bryant 310 furnace flashing LED error code.
    My Bryant 310 furnace is flashing error code. 3 quick flashes, 3 long flashes. What does this mean?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Oct 9, 2011, 07:01 PM
    LIMIT CIRCUIT FAULT - Indicates a limit, draft safeguard, flame rollout, or blocked vent
    Switch (if used) is open. Blower will run for 4 minutes or until open switch remakes
    Whichever is longer. If open longer than 3 minutes, code changes to lockout #13.
    If open less than 3 minutes status code #33 continues to flash until blower shuts off.
    Flame rollout switch and BVSS require manual reset. Check for: - Restricted vent
    - Proper vent sizing - Loose blower wheel. - Excessive wind
    - Dirty filter or restricted duct system.
    - Defective blower motor or capacitor. - Defective switch or connections.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York diamond 90 furnace flashing 3 times need led status code to correct? [ 2 Answers ]

Concord 80 plus furnace flashing error code 6 [ 1 Answers ]

Hi, I have a Concord 80 plus furnace that lights and burns normally. The burners will kick on several times. After the cycle it shuts off and flashes error code six, system lockout. If I shut the power off it will repeat the cycle and shut down again. When I turn the power on the blower kicks on...

My carrier furnace LED light is flashing a code. How do I tell what code it is? [ 1 Answers ]

The error code is flashing and I know certain lengths, long and short indicate a code but how do I tell which one it is?

I have a bryant furnace, and the main burners won't ignite... led code reading 34 [ 1 Answers ]

Goodman Gas Furnace - LED flashing "2" error code [ 11 Answers ]

I have a 5 year old Goodman PGB024075-1A gas furnace. The LED is flashing a "2" error code, meaning an open end switch. I'm attempting to track down the potential causes of this error. After taking things apart, I found and removed an insect nest (the dirt clog kind) which had found its way into...

View more questions Search