Ask Experts Questions for FREE Help !
Ask
    Augie T's Avatar
    Augie T Posts: 9, Reputation: 1
    New Member
     
    #1

    Oct 9, 2008, 06:58 AM
    Blower runs on auto & on for AC, but only on for heat
    I had my blower replaced this summer & it runs well for the AC... when I turned the heat on it only works when it is in the on position, not auto... the themostat I have is programable:(
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Oct 9, 2008, 07:15 AM
    Something is wired incorrectly or the fan limit control for heat is defective. I would start by checking over the wiring you did then if that is OK I would take a meter and check the controls on the furnace. There should be a wiring diagram on the inside of the blower door on the furnace.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heat Pump runs, blower does not [ 3 Answers ]

My Furnace/Heat Pump seems to be working incorrectly. There are times when the Heat Pump outside will run continuously while the thermostat says "heating" however, the blower doesn't come on inside. The coil coming into my furnace unit gets very hot. I have to turn off the unit completely for...

Blower won't come on in auto mode. Heat only [ 2 Answers ]

Carrier 48SB-030080301 1990 model nat gas. On a/c mode works fine. Heat- burner lites but blower will not come on at all unless on manual. I changed the J2 jumper on thermostat from hg to he to see if I could get by for a while and its been working for about a month now. Other than blast of cool...

Oil furnace Blower runs no heat [ 9 Answers ]

I am having a intermintant problem with my furnace, I came home the blower was on no heat , I checked the themostat setting - ficked the service switch off and on a couple of times- burner started, I can hear the burner when it comes on, the furnace ran all day without problem I wake in the night...

Heat runs with ac and even auto kicks on emg heat [ 1 Answers ]

(Coleman Evcon) Some how the hot and cold on the inside thermostat switched.how is that possible?and how do I fix it?

Programmable Thermostat, Fan runs, Heat/Air do not run in Auto setting [ 10 Answers ]

I am installing a Honeywell, RTH230B. My connections are: R to Rh (red jumper to Rc that came with the unit) W to W Y to Y G to G B to nothing The fan comes on (when set to "on").


View more questions Search