Ask Experts Questions for FREE Help !
Ask
    jrostron's Avatar
    jrostron Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 31, 2010, 12:13 PM
    My blower doesnot should down for any thermostat setting
    It is a rudd gas furnace. Changing the thermostat to off does not fix the problem
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Oct 31, 2010, 12:35 PM

    While this is clearly a problem I personally would not worry about it. I turn my stat to ON the day I move into a home and there it stays until I move out. ON 24/7 makes the home more comfortable and uses just a very very small amount more of electricity than the AUTO setting. Does your furnace have a light switch type switch on a box on the side of the furnace?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #3

    Oct 31, 2010, 03:25 PM

    Do the burners ignite when there is a call for heat, or does the blow just constantly run and no heat is produced at all. If the burners don't ignite when there is a call for heat, you most likely have a tripped high limit or rollout switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat will not keep temperature setting [ 2 Answers ]

The problem we have usually happens when it gets really cold, about 20 Degrees - We have a Lux electronic thermostat, and the furnace will not kick on when the temperatures goes below the setting. We have to manually do this - then the furnace runs for a little bit, enough to raise the temperature...

Can I use emergency heat setting if blower fan is broken [ 2 Answers ]

Can I use my emergency heat setting if my blower fan is broken

Hi. I've been setting my thermostat to [ 11 Answers ]

Hi. My wife is a light sleeper, so we set our thermostat to "fan on" every night. The unit works non-stop all night and creates background noise, in addition to heating the house. Last night, five minutes after setting the thermostat to "fan on", the unit stopped. SILENCE!! Then, a few minutes...

Thermostat setting [ 3 Answers ]

I have a Honeywell RTH5100B it worked on one wall, but we switched it to another and now it is not working. I do not have the manual, but I looked it up on line to see about the wiring and I can not tell with the colors and it shows more wires than what I have.

View more questions Search